7 results found for 'screw clamp'.
Matching rule: Every word must match (produces better results) | Only one word must match (Produces more results)
Try removing a word: screw clamp
Low relevance matches: 220 other results may be of interest to you. Show low relevance matches
7 results found for 'screw clamp'.
Matching rule: Every word must match (produces better results) | Only one word must match (Produces more results)
Try removing a word: screw clamp
Low relevance matches: 220 other results may be of interest to you. Show low relevance matches
IEC Horizontal Pulley 50mm Diameter with Clamp Screw
IEC HORIZONTAL BENCH MOUNTING PULLEY
A 50mm diameter high quality nylon pulley mounted on a strong aluminium frame for clamping to a bench top or similar flat surface to a maximum 25mm thickness. The side of the pulley clamps parallel to the surface of the bench. The clam...
Order code: MF2590-001
IEC Ripple Tank Clamp Screw for Leg with Wing Nut
IEC RIPPLE TANK CLAMP SCREW FOR LEG WITH WING NUT
A clamp screw with wing nut and cupped washer for the leg of the SW3430-001 IEC Ripple Tank.
The stainless steel legs are held to the moulded plastic frame by these aluminium clamp screws. The leg passes through the clam...
Order code: PA3430-010
IEC Ripple Tank Support Bar Clamp Collar & Screw
IEC RIPPLE TANK SUPPORT BAR CLAMP COLLAR AND SCREW
A replacement clamp collar and screw for the PA3430-006 stainless steel bar that supports the variable speed rippler of the SW3430-001 IEC Ripple Tank
Order code: PA3430-016
Boss Head - Die Cast Aluminium Alloy with Plastic Head Clamping Screws
Bosshead, die-cast aluminium, takes up to 19mm diameter rod.
Order code: SC7340
Boss Head - Die Cast Aluminium Alloy with Metal Head Clamping Screws
Die-cast aluminium bosshead, takes up to 24mm diameter rod.
Overall length with clamps fully extended: 180mm
Width: 40mm
Order code: SC7345
IEC Clamp Bench Alloy Universal for 13mm Maximum Rods
IEC UNIVERSAL BENCH CLAMP FOR UP TO 13mm RODS
The IEC designed alloy Universal Bench Clamp can fit to benches up to 40mm thick and, when clamped, can carry rods up to 13mm diameter both vertically and horizontally.
The clamp is complete with large steel knurled head kno...
Order code: LB0858-001
IEC Collision In 2 Dimensions Kit
IEC COLLISION IN 2 DIMENSIONS KIT
This simple device clamps to a bench and allows balls of different mass to collide at angles to calculate the laws of dynamics and mass. The point that the balls reach the floor is shown by carbon paper leaving a mark. A plumb bob from be...
Order code: MF1000-001
7 results found for 'screw clamp'.
,