IEC BASIC ELECTRONICS KIT
The IEC Basic Electronics Kit contains components to teach basic electronic theory using a large range of experiments and investigations. The components have synthetic rubber feet that press and hold firmly into blue perforated back plates that can be locked together to expand the working area. All connections are made on the top surface of the components for total flexibility and to avoid confusion. The special 2mm stackable links, with adaptors to 4mm where required, avoid a tangle of wires on the components.

The quality digital meters provided are for both AC and DC, including capacitance measuring ranges. The system is operates with a 12V PlugPak and is complete with mini regulated power supply and mini signal generator.

The kit is fully self contained in a strong carry case complete with an extensive experiment manual. All the included components can be purchased separately as replacements or to extend the kit.

Included:
• Mains Plug Pack for 12V AC at 1 amp
• 2 battery holders for D sized batteries
• Voltage regulator module for smoothly adjustable DC voltage 1 to 12V DC at 1A
• Signal Generator module for sine and square waves from 0.1Hz to 10kHz at 0.1A
• Speaker for emitting sounds
• Microphone for speech and sound
• 2 x digital multimeters with DC and AC ranges
• 30 jumper links in red, blue, black and yellow
• 15 jumper cables with 2mm stackable plugs
• 6 jumper cables with 4mm stackable plugs
• 220 ohm 3W potentiometer
• 10k ohm 0.5W potentiometer
• Resistors in housings: 1 x 100Ω, 1 x 470Ω, 1 x 1kΩ, 2 x 10kΩ, 1 x 47kΩ, 1 x 100kΩ, 1 x 470kΩ
• Capacitors in housings: 1 x 0.1µF, 2 x 1.0µF, 1 x 10µF bipolar, 1 x 100µF electro, 1 x 1000µF electro
• 2 x 1A diodes in housings
• 6.2V Zener diode in housing
• Bridge rectifier in housing
• 3 x small signal transistors (2 x NPN, 1 x PNP)
• 2 x power transistors (NPN and PNP)
• 2 x lamp holders in housings
• One way single pole switch in housing
• Two way single pole switch in housing
• Press button switch
• LED white light source
• Light sensitive resistor (LDR)
• Heat sensitive resistor (NTC)
• 3 LEDs (1 each red, green and yellow)
• Connector box for alligator clips
• 10 x MES lamps for small currents
• 4 x alligator clips to fit to banana plugs
• 4 x alligator clips fitted with banana plugs
• 2 x stainless steel conductivity plates

NOTE: This is a genuine IEC product.
We believe in supporting Australian industry and only sell genuine IEC products, we do NOT sell imported clones of IEC products.

Last edited 20th Feb 2024